Date Created: 12/2/16 (after several times of making these)
Difficulty Level: Intermediate
Time to Complete: 30 minutes
Materials Needed:
3/8″ grosgrain ribbon
Tree branches: emerald green, green print with ornaments or green print with snowflakes
Bow: red, white, pink, silver, gold, any color (saddle stitch, polka dot, pattern print, sheer glittery)
Trunk clip liner: brown or brown with polka dots
Jem or rhinestone optional
needle and thread for bow
hot glue
salon clip, badge holder, magnet, pin…whatever you are going to mount it on
Measurements: (and what the pieces are for)
(12) 2″ for tree branches
(1) 4.5-5″ for bow
(1) 4.5″ for trunk clip liner
Instructions:
- Heat seal ends of all ribbons
- For each branch, place a dot of glue on top of one end, place the other end on top at an angle to create a teardrop shape, leaving a small hole in the center. Repeat for all 12 branches
- Mount 4 branches together. Mount 3 branches together. Mount 3 branches together again. Mount 2 branches together.
- Line clip with ribbon for tree trunk.
- Glue bottom wrung of 4 branches near the bottom of the clip. Next glue 3, then 3, then 2.
- Make bow topper and glue on top of tree. Embellish bow.
Notes:
- Tree can be emerald or any other green (but no one purchased the dark evergreen color) and everyone LOVED when I made it with the light green that had an ornament Christmas pattern with a red with white saddle stitch bow. I personally liked it better with the white with red saddle stitch bow.
- Keep hole in loop small
- Don’t angle bottom row in too much, keep in more level
- Really Spread the 3 out
- Glue each row together first, then glue the row to the clip. The top most row will run out of clip and just be glued to the previous row.
- If making it on a badge pull, simply fold the clip liner in half and glue turner for more stability. Charging $7 for badge pull tree, probably $6 or $6.50 on a clip
More examples: